Data Sheet

If ‘Auto Mode’ is chosen, the module will monitor the power-on environment. When the platform is stationary, the module

will switch to ‘Static Boot’, otherwise ‘Dynamic Boot’ will be used. Note that under rare conditions, the module makes bad

decisions. ‘Auto Mode’ may also take longer time to boot. As such, it is recommended to explicitly tell the module which

mode to boot if the user scenario is known.

Calibration Panel

The calibration panel can be opened through the button as shown in Figure 23. It will then pop-up in section 3 shown in Figure

Depending on the TransducerM model and firmware version, you will see different configurations in the pop-up panel. For

example, a minimum setup includes a static calibration 'CalibB' button. Shown in Figure 24. The use case of the 'CalibB' has

been described in section 'Boot Mode' on page 14. For other options in the panel, they are usually special controls for a

particular customer type and there should be descriptions in the user interface.

Figure 23: Button to open Calibration Panel

Figure 24: Calibration Panel minimum setup