Data Sheet

Step 3 – Record data

If you would like to record TransducerM testing output data into log files saved on your PC, perform this step.

Procedure Instruction Comment

Disable the 'Status' output in the ImuAssistant

We don’t want to record ‘Status’ data, instead, what we are

interested in are the ‘Raw Data’ and ‘RPY’. Disabling

unwanted output data speeds up the refreshing rate of useful

data.

Make sure 'Raw Data' and 'RPY' is selected

The configuration should now look like this:

Click the 'Record' button on the bottom-right of the

ImuAssistant

Select the file saving directory

It is recommended to select file locations such as 'My

Document', instead of the application installation path, to avoid

possible 'writing permission forbidden' issue.

Step 4 – Run the Test

If TransducerM is attached to a vehicle, align the X-Axes of TransducerM with the front direction of the vehicle.

You can now move and rotate the TransducerM or drive the vehicle with TransducerM attached. All selected data outputs are

recorded, which can be used for later analysis. The Total File Size should accumulate over time.

Step 5 – Save the Recorded Data and Finish

Click the 'Stop & Save' button at the end of the test.

For more details regarding the data recorder, refer also to section ‘Data Recorder’ on page 20.

Figure 16: Data recorder panel during the test

Figure 17: Data recorder saves and closes files