Data Sheet

Save Settings and wait for 3 seconds.

Save the settings by clicking the big 'Save Settings' button and wait for 3

seconds.

Power off TransducerM

Step 2 – Heat Up

When the 'Step 1 – Restore Default Setting' is completed, continue with the following procedures, which allows and makes

sure that TransducerM is ready to deliver its optimal performance.

Procedure Instruction Comment

TransducerM power on

If it is already powered on, restart it by power cycling it.

Wait 15 seconds

To ensure the initialization procedure finishes.

Open ImuAssistant, scan and open TransducerM

You will see the output data being displayed on ImuAssistant

after opening.

Enable the 'Status' output in the ImuAssistant

To enable the 'Status' output, check it as shown below:

Put TransducerM on static ground. Keep it

completely stationary and do not move it.

Wait for approximately 5 minutes, until

ImuAssistant shows QoS (Quality-of-Service) as

'5 Very Good'. Heat up done.

QoS information can be found in the top-right corner of

ImuAssistant:

Keep TransducerM and ImuAssistant running, and

perform the next step.

If TransducerM is powered off accidentally, repeat all

the procedures in section 'Step 2 – Heat Up'. It is

extremely important for QoS to reach the fifth level.