Programming Instructions

Safety and environmental instructions Page 8/74
II. Safety and environmental instructions
Please:
 Read this manual carefully before the unpacking, the installing or the commissioning of this equipment
 Take into account all the hazards and of recommended precautionary measures
The failure to respect these procedures can result in serious injury to users or damaging the device.
1) Use of the equipment
SYCLOPE ODITouch
®
controllers has been designed to mesure and control pH, Chlorine, Bromine (BCDMH) using
appropriate sensors and actuator controls within the scope of use described in this manual.
All other uses are considered to be non-conforming and must therefore be forbidden. SYCLOPE
Electronique S.A.S. will not be responsible in any case for any damage that result from such uses.
2) User obligations
The user undertakes not to allow its employees to work with the SYCLOPE ODITouch
®
controller described in this
manual unless they:
 Are aware of the fundamental instructions relating to work safety and prevention of accidents
 Are trained in the use of the device and its environment
 Have read and understood these instructions, warnings and manipulation rules
3) Risk prevention
The installation and connection of the SYCLOPE ODITouch
®
controller should be only performed by
specialized personnel and qualified for this task.
The installation must comply with the current safety standards and instructions!
Before opening the controller or manipulate the relay outputs, always remember to switch-off the primary
power supply!
Never open the controller when it is powered on!
Maintenance operations and repairs should be only performed by trained and specialized personnel!
Take care when choosing the location for installing the controller!
SYCLOPE ODITouch
®
controller should not be installed in a hazardous environment and should be
protected against splashing with water or chemical products. It should be installed in a dry, well-ventilated
and isolated location.
Make sure that the chemical sensors used with this controller correspond well to the chemicals used. Refer
to the individual technical note of each sensor. Chemistry of water is very complex, in case of doubt,
contact immediately our engineering service or your approved installer/reseller.
Chemical sensors are sensitive elements using consumable parts. They must be supervised, maintained
and calibrated regularly using specific calibrator systems not-provided with this equipment. In the event
of defect, a surplus possible hazard of chemical injections can be noted. In the doubt, a service contract
must be taken near your reseller/installer or failing this near our engineering services. Contact your
approved installer/reseller or our business service for more information.