Programming Instructions

Programming screen « INSTALLATION » Page 71/74
 Not used inputs
 Inputs MIx
These two channels (MI1 and MI2) appear only if the conductivity module is connected.
7) Menu « User » - « OUTPUTS TEST » [0711]
« OUTPUTS TEST » menu will allow you to control relays or 4…20mA outputs to set pumps.
Press to open following screen.
 PO1 Dosing
- Output name and function affected, press to toggle ON/OFF the relay.
Each press reverses the state.
Relay output is inactive
Relay output is active
 AO1 Transfer
- Output name and function affected, press to open the numeric keyboard and enter the desired value
Even unaffected outputs can be tested.
OUTPUTS TEST
Outputs test
PO1 Dosing PO2 Dosing
FO1 Alarm FO2 Not used
RO1 Not used
RO2 Not used
Not used
Not used Not used Transfer
AI2 - - - mA
Not used
Channel
number
Raw value of the signal
Unit of channel concerned
MI2 120,18 Ω 52,7 °C
Temperature - Offset : 0,0mA – Slope 100%
MI1 823,21 Ω 1,2 mS/cm
Conductivity - Offset : 0,0mA – Slope 100%
Channel
number
Raw physical measurement
value and u
nit according to
channel type
Calibrated measurement value and
unit according to channel type
Configuration