Programming Instructions

Programming screen « INSTALLATION » Page 70/74
6) Menu « User » - « INPUTS TEST » [0611]
« INPUTS TEST » menu will allow you to view raw values and measurement values of all selected
inputs.
Press to open following screen.
 Analog sensor inputs
 Contact inputs
 Flowrate input
 Fuses state
INPUTS TEST
AI1 - - - mA - - - mg/l
Free chlorine - Offset : 0,0mA – Slope 100%
Channel
number
Raw physical measurement
value and u
nit according to
channel type
Calibrated measurement value and
unit according to channel type
Sensor type Actual calibration
Sensor state
Sensor Out of
order
Maintenance
Unstable
Channel
number
Configuration
Input state
Open
Close
DI1 Open
Water circulation
DI1 7,2
Flowrate – Slope : 100%
Channel
number
Configuration
Input state
Flowrate
Calibrage actuel
Inputs test
PI1 0 mV 7,00 pH
pH - Offset : 0mV – Slope 100%
PI2 0 mV
Not used
AI2 - - - mA
Not used
AI4 - - - mA
Not used
AI1 0.03 mA - - - mg/l
Free chlorine - Offset : 0,0mA –Slope 100%
AI3 15,00 mA 29,4 °C
Temperature - Offset : 0,0mA – Slope 100%
DI1 Open
Water circulation
DI2 Close
R.C.I command
DI3 Close
Other
DI4 Close
Bott. Level Tank
F1
PO1 output fuse
F2
PO2 output fuse
F1
PO1
output fuse
Channel
number
Output number
Fuse state
OK
KO
MI1 823,21 Ω 1,2 mS/cm
Conductivity - Offset : 0,0mA – Slope 100%
MI2
120,18 Ω 52,7 °C
Temperature - Offset : 0,0mA – Slope 100%