Programming Instructions

Programming screen « INSTALLATION » Page 56/74
7) Menu « Settings » - « TRANSFERs 4…20mA » [0721]
« TRANSFERs 4…20mA » menu will allow you to adjust the low and high threshold of the transfers
4…20mA.
Press to open following screen.
This menu is only accessible if you have set up a 4…20mA sensor in the “INSTALLATION” part.
Otherwise it remains grey.
The screen shows the parameters to which a 4…20mA output is assigned in transfer mode. You can, by
pressing an active parameter, configure the transfer thresholds.
Parameter type with assigned transfer.
Press to create or edit the thresholds transfer.
Parameter type has no transfer affected.
Parameter isn’t configured.
E01 to E08 Parameters identification.
Press to open following screen.
TRANSFERS
4…20mA
4…20mA Transfer settings
Parameters with 4…20mA tranfer assigned
pH Free chlorine
Temperature Flowrate
Volume
pH