Programming Instructions

Programming screen « INSTALLATION » Page 54/74
In the example above the pH parameter has a flowrate sensor affected in packaging. The threshold setting of
the flowrate control will be specific to the pH parameter.
The screen shows the parameters & “flowrate” parameters that are configured. You can, by pressing and
active parameter, configure the flowrate.
 See previous page for flowrate threshold setting
6) Menu « Settings » - « TANK LEVEL 4…20mA » [0621]
« TANK LEVEL 4…20mA » menu will allow you to adjust the low threshold of the tank volume that
enslave dosages.
Press to open following screen.
This menu is only accessible if you have set up a volume sensor in the “INSTALLATION” part. Otherwise it
remains grey.
a) « Standard » version
Volumes are only parameters. The control and low threshold setting are applied at the parameter level and
will be the same for all parameters that are controlled by this volume.
The screen shows the volume type parameters that are configured. By pressing, an active parameter, you
can configure the bottom threshold of the tank.
Volume type parameter.
Press to create or edit the flowrate configuration.
Parameter type isn’t volume
Parameter isn’t configured.
E01 to E08 Parameters identification.
Press to open following screen.
TANK LEVEL
4…20mA
Tank level settings 4…20mA
Volume settings
pH Free chlorine
Temperature Flowrate
Volume
Volume