Programming Instructions

Programming screen « INSTALLATION » Page 51/74
 Type Manual
- Compensation mode selection, this selection button displays the
selected mode information (
Manuel). Press to change it.
 Unit °C
- Temperature unit selection that you will enter in the numeric
keyboard part, on this selection button you will find the selected unit
information (°C).
Press to change it.
 Type Sensor AI3
- Compensation mode selection, this selection button displays the
selected mode information (
Sensor) and the corresponding entry
(
AI3).
Press to change it.
When temperature compensation is enabled, an icon appears next to the measurement value in the
calibration status area.
Programmed and active compensation
Programmed compensation with a sensor but the sensor measurement
value isn’t correct.
The calibration isn’t blocked, but the compensation will be done with T =
25°C.
Compensation
This choice will be valid as
long as you stay in the
calibration of this sensor
Type Manual
* Enter the value on the
keypad on the right
Unit °C
Compensation
This choice will be valid as
long as you stay in the
calibration of this sensor
Type Sensor AI3
Sensor
Me
a
sure
: 7,00pH
Raw signal : 0mV
Sensor
Me
a
sure
: 7,00pH
Raw signal : 0mV