Programming Instructions

Generality Page 5/74
I. Generality
1) Scope
SYCLOPE ODITouch
®
analyser/controller you have purchased is a high-tech eletronic device. It was designed and
created carefully for your enjoyment and your peace of action.
Its remarkable faculty to adapt to different swimming pool structures allows it to settle in all difficult envirenments
where mastery of water treatement is most decisive.
Thanks to ODITOUCH ease of use, their user-friendliness and their remarkable technicality, you will fully enjoy its
many possibilities and will be assured of a perfect control and perfect monitoring of your pool water quality.
You will find in the instructions that follow, all the information needed for the installation, use and maintenance of
your new equipment.
 Packaging
 Installation
 Basic equipements
 Specifications
 Commisioning instructions
 Safety instructions
If you need more information or if you encounter problems that not have been specified in this guide, please quickly
contact your retailer or SYCLOPE Electronique S.A. sales department, either at the agency or office in your area, or
at technical/quality service at our head office. We will do our best to help you and make you enjoy our advice and
our knowledge in the field of measurement and treatment of pools water.
Contact :
[e-mail]
2) FCC conformity
The SYCLOPE ODITouch
®
controller complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference (2) this device must accept any
interference received, including interference that may cause undesired operation FCC
Regulations state that unauthorized changes or modifications to this equipment may void
the user’s authority to operate it.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect this equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer could void the user’s authority to operate
this equipment.
Remark: To ensure compliance with the FCC regulations on electromagnetic interference for a class B device, use
cables properly shielded and connected to the ground as recommended in this manual. The use of a cable that is not
properly shielded or earthed for risk of violating the FCC rules.
Radio Frequency (RF) Exposure Compliance of Radiocommunication for mobile Apparatus To satisfy FCC RF Exposure
requirements for mobile devices, a separation distance of 20 cm or more should be maintained between the antenna