Programming Instructions

Programming screen « INSTALLATION » Page 36/74
Be careful, when you combine one or more timers, the operation of the parameter becomes dependant
of the time slots.
Parameter is functional during the time slot.
Save:
- When a change is made, the “SAVE” button appears (floppy icon), you must save your configuration
by pressing it.
7) Menu « Configuration des communications » - « COMMUNICATION » [0731]
See. Part 3 « DOC0461 - Communication programming instructions ODITOUCH ENG Rev1».
8) Menu « Configuration & Installation » - « RESET FACTORY » [0831]
« RESET FACTORY » menu will allow you to reset the regulator configuration by choosing some
preset operating options.
Press to open the following screen.
 Sensors
- Select desired sensor configuration from predefined configuration:
o
pH (PI1) – Free Cl (AI1)
o
pH (PI1) – ORP (PI2) – Free Cl (AI1)
o
pH (PI1) – Free Cl (AI1) –Total Cl (AI2)
o
pH (PI1) – ORP (PI2) – Free Cl (AI1) –Total Cl (AI2)
 Relays
- Select desired dose relay configuration from predefined configuration:
o
NO / NC (FO1 & FO2) – PWM dosing mode
o
Electronic (RO1 & RO2) – PFM dosing mode
o
Self-powered (PO1 & PO2) – ON / OFF dosing mode
 Activate pump power management
- When using C.R.T or electronic relays for dosage it’s possible to use the two self-powered relays for
supplying the pumps. To do this you must select this option.
COMMUNICATION
Reset
Factory
Factory reset
Sensors : pH (PI1) – Free CL (AI1)
Relays : NO / NC (FO1 & FO2) –PWM dosing mode
Activate pump power management (PO1 & PO2)
‘Flowswitch’ detector of water circulation present (DI1)
Temperature sensor (4…20mA) present (AI3) – Measure (E05)
Measures :
pH (E01) – Free CL (E03)