Programming Instructions

Programming screen « INSTALLATION » Page 34/74

 Fault Low range

- Selection of the current that will be applied on the output in case of fault encountered, on this

selection button we find the selected current information (

Low range).

Press to change it.

Low range = 4mA if range 4…20mA selected; 0mA if range 0…20mA selected.

0mA = 0mA

2,6mA = 2,6mA

 Out of range 20mA

- Selection of the current that will be applied on the output in case of exceeding the selected operating

range, on this selection button we find the selected current information (

20mA).

Press to change it.

Maximum = higher 22mA

0mA = 20mA

20,8mA = 20,8mA

To delete a 4…20mA output :

- You must select « NO » in the 4…20mA output function and save your configuration by pressing the

“SAVE” button.

6) Menu « Configuration & Installation » - « CONDITIONS » [0631]

« CONDITIONS » menu will allow you to access the configuration of the operating conditions that

are used to control the parameters operation.

Press to open the following screen.

The screen displays the list of configurated and conditionable parameters. You can, by pressing a used

parameter, change the configuration of the applied conditions.

Type of parameter conditionable.

Press to edit the configuration.

Parameter type inactive and not conditionable.

CONDITIONS

Conditions setting

Conditional parameters

pH Free chlorine

Temperature

Not used