Programming Instructions

Programming screen « INSTALLATION » Page 29/74
 Dosage direction FALLING
- See (On/Off) Control dosing mode
 PFM frequency: 180 pulse/min
- Enter the value corresponding to the number of pulses per minute to be generated. Here the value is
(
180). Press to open the numeric keyboard and enter the desired value.
Possible adjustment FO1 & FO2 outputs from
1 to 180 pulse/min
Possible adjustment RO1 & RO2 outputs from 1 to 500 pulse/min
 Dosing range
- See (On/Off) Control dosing mode.
 Delete & Save
- See (On/Off) Control dosing mode
d) Relay outputs in Alarm mode [1531]
Example with creation of a relay in alarm mode.
Press to open following screen.
1
 PO2 Function
Alarm
- Output relay operation mode selection, on this selection button we find the information of the output
being modified (
PO2) and the function currently selected (Alarm). Press to change it.
 Assignement pH E01
- Selection of the parameter to which this relay is attached, on this selection button we find the
information of the parameter type (
pH) and its « code » (E01).
Press to change it.
 Selection of alarms to be taken into account to activate this output:
- Selection of alarm to be considered. « Multiple » selection possible, press desired alarms to
select/deselect. here (
Low threshold – High threshold) are selected.
Alarms list in order of icons :
- Water circulation – Low threshold – High threshold – Out of order sensor – Unstable sensor –
Overdosage – Active polarization – Active timer – Active RIC – Tank bottom
 Rest relay state NO
- Choice of resting state to take inot account, this check box contains the information currently selected
(NO). Press to switch mode to NO (Normally Open) or NC (Normally Close).
Not used
Setting output relay
PO2 Function Alarm Assignment pH E01
Relay delay time
Rest relay state
Run
(ON) : seconde(s)
Stop
(OFF) seconde(s)
Active (ON) second(s)
Inactive (OFF) second(s)
Relay state duration for pulse mode