Programming Instructions

Programming screen « INSTALLATION » Page 26/74
Not used output Timer controlled output
Dosage controlled output State controlled output (contact)
Alarm controlled output 4…20mA transfer output
a) Relay outputs in dose (On / Off) control mode [1531]
Example with editing a relay in dosage mode.
Press to open the following screen
 PO1 Function Dosing
- Output relay operation mode selection, on this selection button we find the information of the output
being modified (
PO1) and the function currently selected (Dosing). Press to change it.
 Assignment pH E01
- Selection of the parameter to which this relay is attached, on this selection button we find the
information of type of parameter (
pH) and its « code » (E01). Press to change it.
 Mode (On / Off) Control
- Dose mode selection, on this selection button you will find the selected mode information ((On /
Off) Control
). Press to change it.
 Dosage direction FALLING
- Dosage direction choice, on this selection button we find the information of the selected dosage
direction (
FALLING).
Press to toggle the mode from RISING to FALLING and change the dosage direction.
To delete a relay output :
- You must select « NO » in the relay function and save your configuration by pressing the “SAVE”
button
Dosing
Setting output relay
PO1 Function Dosing
Assignment pH E01
Mode: (On / Off) Control
Dosage direction
:
FALLING