Programming Instructions

Programming screen « INSTALLATION » Page 23/74
measurement made in correlation with the temperature of the environment. The conductivity value
displayed will then be the compensated value and no longer the measured value.
- On this selection button we find the information of the used entry, here none (- - -).
Press to change it.
Make sure that your sensor doesn’t already have internal temperature compensation. Adding a new
compensation here would distort the measurement.
 Factor 0 %/°C
- If you select a temperature sensor, the compensation factor input becomes active and you must enter
the desired value.
Press to open the numeric keyboard and enter the desired value.
Adjustement possible from
-99,0 to + 99,0 %/°C.
e) Salinity calculation options
If your installation has:
- Conductivity sensor
 Salinity calculation
 Temperature sensor
- See conductivity parameter
 Factor 0 %/°C
- See conductivity parameter.
f) TDS calculation options
If your installation has:
- Conductivity sensor
 Salinity calculation
 Temperature sensor
- See conductivity parameter
 Factor 0 %/°C
- See conductivity parameter
 Factor TDS 0 %/°C
- The TDS calculation is based on a factor that you need to fill in here.
Press to open the numeric keyboard and enter the desired value.
Adjustment possible from 1,0 to 444,0 %.
Temperature compensation
Temperature sensor - - -
Factor %/°C
Temperature compensation
Factor %/°C
TDS factor %
Temperature sensor - - -