Programming Instructions

Programming screen « INSTALLATION » Page 22/74
 E02 Measure Free chlorine
- Parameter type selection, on this selection button we find the information of the parameter in the
process of modification (
E02) and the currently selected measurement type (Free chlorine). Press
to change it.
The choice of measurement is directly related to the sensors installed and configured. The controller will
only give you measurements with the configured sensors.
 Sensor Free chlorine AI1
- Select the type of sensor to associate to the measurement, on this selection button we find the
information of type (
Free chlorine) and input (AI1). Press to change it.
The choice of the sensor is directly related to the type of measurement. The controller will only offer you
the sensors compatible with the selected measurement.
 Unit ppm
- Sensor unit measurement selection, on this selection button we find the information of the currently
selected unit (
ppm). Press to change it.
 Decimal(s) Automatic
- Select the number of decimals to display, on this selection button we find the number information
(
Automatic). Press to change it.
Controller will give you the list of possible decimals.
To delete a measurement or calculation:
- You must select « NO » in the measurement type and save your configuration by pressing the “SAVE”
button.
c) pH parameter options
 Temperature sensor
- pH measurement is dependent on the temperature of the environment. Here you have the possibility
to select a temperature sensor (if there is one installed) which will be used to adapt the measurement
made in correlation with the temperature of the environment. The pH value displayed will then be the
compensated value and no longer the measured value.
- On this selection button we find the information of the used entry, here none (
- - -).
Press to change it.
d) Conductivity parameter options
 Temperature sensor
- Conductivity measurement is dependent on the temperature of the environment. Here you have the
possibility to select a temperature sensor (if there is one installed) which will be used to adapt the
Temperature compensation
Temperature sensor - - -
Temperature compensation
Temperature sensor - - -
Factor %/°C