Programming Instructions

Programming screen « INSTALLATION » Page 21/74
Parameter already configured.
Press to edit its configuration.
Parameter not used.
Press to start its configuration.
E01 to E08 Parameters identification.
In the control screens, the parameters will be identified by their EOx “code”.
 Common symbols
Parameter Not used Measured parameter Calculated parameter
a) Parameter configuration [1431]
Press to open the following screen.
 E04 Measure None
- Selection of the parameter type, on this selection button we find the information of the parameter in
the process of modification (
E04) and the measurement type currently selected (None). Press to
change it.
The choice of measurement is directly related to the sensors installed and configured. The controller will
only give you measurements with the configured sensors.
When selecting the measurement, the controller will automatically complete the parameter configuration
files using the information from the first compatible sensor available in its list. You can change this
configuration if necessary.
b) Parameter configuration - « simple »
« Base » screen of a parameter configuration. Depending on the parameter chosen (measured, caculated,
compensated…) additional configuration options are added on the right track (ZONE “Options”).
Not used
Measure & calculation setting
E04 Measure
None
Measure & calculation setting
E02 Measure
Free chlorine
sensor Free chlorine AI1
Unit ppm
Decimal(s) Automatic
ZONE
« OPTIONS »