Programming Instructions
Programming screen « INSTALLATION » Page 20/74
General programming instructions
Monday – Tuesday – Wednesday – Thursday – Friday – Saturday – Sunday
- Selection of the day(s) of the week timer will be active. Type of “multiple” selection, press desired
days to select/deselect. Here (
Monday – Tuesday – Wednesday – Thursday – Friday) are
selected.
Starting time
08:00 – End time 18:00
- Select time to start and end the time slot one after the other. Here the value is (08:00) & (18:00).
Press Starting time and/or End time one after the other to open the numeric keyboard and enter the
desired time.
Starting date --/--/---- End date --/--/---
- Select timer activation only in a period between two dates. Here no value entered (--/--/----) & (--
/--/----
), Both fields are disabled for a clock with no defined period.
To enable date management, the corresponding box must be unchecked
Reccurence of programmation 1 week(s)
- Weeks recurrence selection. Here the value entered is (1), timer active every week. Type 2 for 1
week/2, 3 for 1 week/3 etc. Adjustment possible from
1 to 52.
Erase
- Clears the time slot configuration.
4) Menu « Configuration & Installation » - « MEASURES & CALCULATIONS » [0431]
« MEASURES & CALCULATIONS » menu will allow you to access the configuration of the
measurements managed and displayed by the controller. This can be a “simple” measurement with
a sensor or a calculation with multiple sensors. The device will give you a list of possible parameters
based on the sensors you have configured previously.
Press to open the following screen.
If the option « Create a parameter automatically for each sensor» is enabled when opening this
screen, the list of parameters “simple” will already be present.
The order of the parameters is completely independent of the order of the sensor. If the option « Create
a parameter automatically for each sensor» is enabled, the order of the parameters created will
correspond to the order in which you have added and configured your sensors.
The screen shows the parameters that are already configured and those not used. You can, by pressing a
parameter already configured; change its configuration, or by pressing a parameter not used configure it.
MEASURES
CALCULATIONS
Setting parameters
Mesures & Calculs
pH Free chlorine
Temperature Not used
Not used Not used
Not used Not used