Installation Instructions

Generality Page 6/67
Installation and starting instructions
2) FCC conformity
The SYCLOPE ODITouch
®
controller complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference (2) this device must accept any
interference received, including interference that may cause undesired operation
FCC Regulations state that unauthorized changes or modifications to this
equipment may void the user’s authority to operate it.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect this equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer could void the user’s authority
to operate this equipment.
Remark: To ensure compliance with the FCC regulations on electromagnetic interference for a class B
device, use cables properly shielded and connected to the ground as recommended in this manual. The
use of a cable that is not properly shielded or earthed for risk of violating the FCC rules.
Radio Frequency (RF) Exposure Compliance of Radiocommunication for mobile Apparatus To satisfy FCC
RF Exposure requirements for mobile devices, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during operation. To ensure compliance,
operation at closer than this distance is not recommended. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Contains:
- WiFi module: FCC ID : 2AC7Z-ESPWROOM02
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
- GSM module: FCC ID: UDV-0912142009007
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. (for FCC)