Installation Instructions

Annexes Page 58/67
Installation and starting instructions
IX. Annexes
1) “Configuration & Installation” – “Reset Factory” menu [0831]
Press then and to open following screen.
« Reset Factory» menu will allow you to reset the controller configuration by choosing a few predefined
opertating options..
 Sensors
- Select the sensor configuration, from the predefined configurations :
o pH (PI1) – Free Cl (AI1)
o pH (PI1) – ORP (PI2) – Free Cl (AI1)
o pH (PI1) – Free Cl (AI1) – Total Cl (AI2)
o pH (PI1) – ORP (PI2) – Free Cl (AI1) – Total Cl (AI2)
 Relays
- Select configuration of the dosing relays, from the predefined configurations :
o NO/NC (FO1 & FO2) –PWM dosing mode
o Electronic (RO1 & RO2) –PFM dosing mode
o Self-powered (PO1 & PO2) – ON/OFF dosing mode
Reset
Factory
Reset Factory
Sensors : pH (PI1) – Cl libre (AI1)
Relays : C.R.T (FO1 & FO2) –PWM dosing mode
Activate pump power management (PO1 & PO2)
« Flowswitch » detector of water circulation present (DI1)
Temperature sensor (4…20mA) present (AI3) – Measure (E05)
Measures :
pH (E01) – Free Cl (E03)
Menu
INSTALLATION