Installation Instructions

Input mode Page 48/67
Installation and starting instructions
o Slope (Example pH) :
 Display the state of the sensor slope calibration
 The more the bargraph becomes red, the more the calibration limit is reached.
This information can be a sign of sensor aging.
 The slope is expressed in percentage and may vary from 0% to 200%, 100%
represents a slope without calibration.
If an incorrect or out-of-scale value is entered, the « Min : 0 –
Max : 14.00 » is displayed in red when you press « Enter »
Correct value Incorrect value
If the value entered is correct, a « Calibration performed with
success » window appears.
3) Graphical channel history display
Press to display the following screen:
Calibration
Min:0
–
Max:14.00
o
«
Calibration
» button
6.95 pH
Slope
58%
History
Lateral banner
Recording screen
Cursor information
History
page 1/1
Cursor information
20/04/2020 – 09h33
PArameter state :
Low alarm 6.00
High Alarm - - - -
Setpoint 6.90
Value 7.00
Inactive
Halt
Polarzation
Circulation
Dosing
Sensor fault
Alarm
Bott. level tank
Overdosing
Uploading
Controller ON