Installation Instructions

Installation and connections Page 25/67
Installation and starting instructions
Connection of a flow switch sensor on DI2:
 Remove the protective sheath.
 Strip the wires on 7mm.
 Pass the cable through the cable gland.
 Connect the brown power strand to DI2 + (33).
 Connect the blue power strand to DI2 – (35).
 Connect the black contact strand to DI2 sw (34).
 Tighten the cable gland to seal
Connection of a flowmeter sensor on DI3:
 Preferably use a two-strand cable.
 Connect one sensor strand to the DI3 sw (23) connection.
 Connect the other sensor strand to the DI3 - (24) connection.
 Tighten the cable gland to seal.