Programming Instructions

SYCLOPE ODITOUCH setting Page 28/40
Communication programming instructions
g) Modbus Slave configuration |7731]
Press to open the following screen.
 Slave type CONTROLLER
- Selection of the type of slave connected on the RS485 bus, on this selection button we find the
information of the selected type (CONTROLLER). Press to change it.
 Address
- Entering the slave’s modbus address. Caution it must be different from the modbus address of
your regulator.
Press to open the numeric keyboard and enter the desired value.
Possible adjustment from 1 to 247.
 Test
- Pressing the Test button verifies that the slave is correctly connected. You must first make the
RS485 wired connection between the 2 devices and check that the modbus configuration is
identical on the 2 devices.
MODBUS
SLAVES
Configuration of slaves
Slave type CONTROLLER Address 1 Test
Slave type NO Address 1 Test
Slave type NO Address 1 Test
Slave type NO Address 1 Test