Programming Instructions

Programming screen « Setup menu » Page 70/78
General programming instructions
6) Menu « User » - « INPUTS TEST » [0611]
« INPUTS TEST » menu will allow you to view raw values and measurement values of all selected
inputs.
Press to open following screen.
 Analog sensor inputs
 Contact inputs
 Flowrate input
 Fuses state
INPUTS TEST
AI1 - - - mA - - - mg/l
Free chlorine - Offset : 0,0mA – Slope 100%
Channel
number
Raw physical measurement
value and u
nit according to
channel type
Calibrated measurement value and
unit according to channel type
Sensor type
Actual calibration
Sensor state
Sensor Out of
order
Maintenance
Unstable
Channel
number
Input state
Open
Close
Configuration
DI1 Open
Water circulation
DI1 7,2
Flowrate – Slope : 100%
Channel
number
Configuration
Input state
Flowrate
Actual calibration
INPUTS TEST
RI1 10,9 Ω 22,6 °C
Temperature - Offset : 0 Ohm – Slope 100%
RI2 2170 Ω 0,5 mS/cm
Conductivity - Offset : 0.0 mA– Slope 100%
AI2 - - - mA
Not used
SI2 10 °C 10,0 °C
Temperature - Offset : 0,0mA – Slope 100%
AI1 10,00 mA 5,00 mg/l
Free chlorine - Offset : 0,0mA –Slope 100%
SI1 100 Ω 100 µS/cm
Conductivity - Offset : 0,0mA – Slope 100%
DI1 Open
Volume counter
DI2 Open
Water flow switch
DI3 Open
Tank level
DI4 Open
Not used
F1
PO1 output fuse
F1
PO1
output fuse
Channel
number
Fuse state
OK
KO
Output number
DI5 Open
Not used
SI1 Open
Water flow switch