Programming Instructions

Programming screen « Setup menu » Page 38/78
General programming instructions
Special case of a Dosing function
 AO1 – Function Dosing
- Output 4…20mA function mode selection, on this selection button you can choose the function of the
4…20mA output (AO1).
Press to change it.
 Affection Volume E01
- Selection of the parameter to which this output 4…20mA is attached, on this selection button we find
the configuration type information (Volume) and its « code » (E01).
Press to change it.
 Output range 4…20mA
- Selection of the Ooutput range.
Press to choose between 4…20mA and 0…20mA.
 Dosing direction Up
- Dosage direction choice, on this selection button we find the information of the selected dosage
direction (Up).
Press to toggle the mode from Up to Down and change the dosage direction.
 Minimum 0 %
- Enter the value of the Minimum. Here the value is (0).
Press to open the numeric keyboard and enter the desired value.
Possible adjustment from 0 to 100 %
 Maximum 0 %
- Enter the value of the Maximim. Here the value is (0).
Press to open the numeric keyboard and enter the desired value.
Possible adjustment from 0 to 100 %
 Keep active after
- The box is automatically active and cannot be modified
To delete a 4…20mA output:
You must select « None » in the 4…20mA output function and save your configuration by pressing the
“SAVE” button.
4…20mA output settings
Output range 4…20mA
AO1 - Function Dosing Affection Volume E01
Dosing direction UP
Minimum
Maximum
Keep active after
Dosing range
0
100
%
%