Programming Instructions

Programming screen « Setup menu » Page 36/78

General programming instructions

Special Dosing function

 FO3 Function Dosing

- Output CRT relay operation mode selection, on this selection button we find the information of the

output being modified (FO3) and the function currently selected (Dosing). Press to change it.

 Affection Conductivity E02

- Selection of the parameter to which this relay is attached, on this selection button we find the

information of type of parameter (Conductivity) and its « code » (E02). Press to change it

 Mode On/Off

- Dose mode selection, on this selection button you will find the selected mode information (On/Off).

Press to change it.

 Dosing direction Up

- Dosage direction choice, on this selection button we find the information of the selected dosage

direction (Up).

Press to toggle the mode from Up to Down and change the dosage direction

 Tank low level detection,

- See previous paragraph

Relay settings

FO3 - Function Dosing Affection Conductivity E02

Mode On/Off Dosing direction Up

Tank low level detection None

Pump flow rate

Tank volume

l/h

Enable compute