Programming Instructions

Programming screen « Setup menu » Page 34/78
General programming instructions
a) 220V Relay outputs [0531]
 PO1 - Bleed valve Enabled
- This window shows the status of the Bleed valve. You can’t change it from this window.
 Mode - Conductivity / Volumetric
- Selection of the main running mode of your coolpac controller.
b) CRT Relay outputs FO1 & FO2[1531]
 FO1 Biocide A
- By checking or unchecking the check box you can choose to enable/disable the Biocide A relay. It’s
disabled by default
 Operating mode Timer
- Operating mode selection, on this selection button we find the selected operating mode information
(Timer). Press to change it.
 Pre-bleed mode None
- Pre-bleed mode selection, on this selection button we find the selected mode information (None).
Press to change it.
 Enable post-bleed lock
- By checking or unchecking the check box you can choose to enable/disable the post-bleed lock. It’s
disabled by default.
Relay settings
FO1 – Biocide A
Relay enabled
Operating mode
Timer
Pre-bleed mode None
Tank low level detection Switch level DI2
Pump flow rate
Enable post-bleed lock
Tank volume
Enable compute
l/h l 0 0
Bleed valve setting
PO1 - Bleed valve
Enable
Mode - Conductivity
Mode - Volumetric
Warning!
Changing the mode will erase the general operating history.