Programming Instructions

Programming screen « Setup menu » Page 33/78
General programming instructions
5) Menu « Setup menu » - « OUTPUTS » [0531]
« OUTPUTS » menu will allow you to access the configuration of relays and 4…20mA outputs that
will be used.
Press to open the following screen.
The screen shows the outputs that are already configured and those not used. You can, by pressing and
already configured output, changing its configuration, or pressing an unused output, configure its installation.
PO1 220V relay outputs is fixed for Bleed valve
FO1 & FO2 CRT relay outputs are fixed for Biocide A and Biocide B
FO3 CRT relay output could be used for Inhibitor or Dosing.
FO4 CRT relay output could be used for Dispersant or Dosing.
AO1 & AO2 are outputs used for transfer or dosing.
Output already configured.
Press to edit its configuration.
Output not used.
Press to configurate.
For your comfort, you will find the notation of the outputs POx, FOx, ROx, AOx screen-printed in front of
the connection terminal block of your device.
OUTPUTS
Outputs setting
PO1 – Bleed valve Enabled
RO1 – Alarms
FO1 – Biocide A Enabled
FO3 – Disabled
FO4 – Dispersant Enabled
FO2 – Biocide B Enabled
AO1 – Transfer Enabled AO2 – Transfer Disabled
F01
–
Biocide A
Enabled
F04
–
Dis
abled