Programming Instructions

Programming screen « Setup menu » Page 32/78
General programming instructions
 Temperature sensor
- Conductivity measurement is dependent on the temperature of the environment. Here you have the
possibility to select a temperature sensor (if there is one installed) which will be used to adapt the
measurement made in correlation with the temperature of the environment. The conductivity value
displayed will then be the compensated value and no longer the measured value.
- On this selection button we find the information of the used entry, here none (- - -).
Press to change it.
Make sure that your sensor doesn’t already have internal temperature compensation. Adding a new
compensation here would distort the measurement.
 Factor 0 %/°C
- If you select a temperature sensor, the compensation factor input becomes active and you must enter
the desired value.
Press to open the numeric keyboard and enter the desired value.
Adjustment possible from -99,0 to + 99,0 %/°C.
f) Salinity zone options
If your installation has:
- Conductivity sensor
 Salinity calculation
 Temperature sensor
- See conductivity parameter
 Factor 0 %/°C
- See conductivity parameter.
g) TDS zone options
If your installation has:
- Conductivity sensor
 Salinity calculation
 Temperature sensor
- See conductivity parameter
 Factor 0 %/°C
- See conductivity parameter
- Factor TDS 0 %/°C
- The TDS calculation is based on a factor that you need to fill in here.
Press to open the numeric keyboard and enter the desired value.
Adjustment possible from 1,0 to 444,0 %.
Temperature compensation
TDS Factor 0 %/°C
Temperature sensor - - -
Factor 0 %/°C
Temperature compensation
Temperature sensor - - -
Factor 0 %/°C