Programming Instructions

Programming screen « Setup menu » Page 31/78
General programming instructions
d) Measure setting configuration [4431]
« Base » screen of a parameter configuration. Depending on the parameter chosen.
 E04 - Measure Free chlorine
- Parameter type selection, on this selection button we find the information of the parameter in the
process of modification (E04) and the currently selected measurement type (Free chlorine). Press
to change it.
The choice of measurement is directly related to the sensors installed and configured. The controller will
only give you measurements with the configured sensors.
 Sensor Free chlorine AI1
- Select the type of sensor to associate to the measurement, on this selection button we find the
information of type (Free chlorine) and input (AI1). Press to change it.
The choice of the sensor is directly related to the type of measurement. The controller will only offer you
the sensors compatible with the selected measurement.
 Unit mg/l
- Sensor unit measurement selection, on this selection button we find the information of the currently
selected unit (mg/l). Press to change it.
 Decimal(s) Automatic
- Select the number of decimals to display, on this selection button we find the number information
(Automatic). Press to change it.
Controller will give you the list of possible decimals.
To delete a measurement or calculation:
- You must select « NONE » in the measurement type and save your configuration by pressing the
“SAVE” button.
e) Conductivity zone options
Measure setting
E04
-
Measure
Free chlorine
Sensor Free chlorine AI1
Unit mg/l
Decimal(s) Automatic
ZONE
« OPTIONS »
Temperature compensation
Temperature sensor - - -
Factor 0 %/°C