Programming Instructions

Programming screen « Setup menu » Page 27/78
General programming instructions
4) Menu « Setup menu » - « MEASURES » [0431]
« MEASURES » menu will allow you to access the configuration of the measurements managed and
displayed by the controller. This can be a “simple” measurement with a sensor or a calculation with
multiple sensors. The device will give you a list of possible parameters based on the sensors you
have configured previously.
Press to open the following screen.
If the option « Create a parameter automatically for each sensor» is enabled when opening this
screen, the list of parameters “simple” will already be present.
The order of the parameters is predefined.
E01 – Volume
E02 – Conductivity
E03 – Temperature
E04 & E05 – Depend of connected probes.
The screen shows the parameters that are already configured and those not used. You can, by pressing a
parameter already configured; change its configuration, or by pressing a parameter not used configure it.
Parameter already configured.
Press to edit its configuration.
Parameter not used.
Press to start its configuration.
MEASURES
Measures setting
E01 – Volume Enabled
E02 – Conductivity Enabled
E03 – Temperature Enabled
E04 – Free chlorine Enabled
E05 – Disabled
E01 – Volume Enabled
E05 – Disabled