Programming Instructions

Programming screen « Setup menu » Page 24/78
General programming instructions
3) Menu « Setup menu » - « DIGITAL INPUTS » [0331]
« DIGITAL INPUTS » menu will allow you to access the configuration of the sensors that will be
connected on the digital inputs.
Press to open the following screen.
Screen presents digital inputs that are already configured and those that are not used. By pressing an
already configured entry, you can change its configuration, or pressing an unused entry, configure its installation.
Entry already configured.
Press to edit its configuration.
Entry unused.
Press to configure its installation.
DI1 to DI5 Water Flow switch, Remote control command, Tank level, Flow meter, Volume counter.
For your comfort, you will find the notation of the RIx, SIx and AIx inputs silkscreen in front of the
corresponding connection terminal block of your device.
DIGITAL
INPUTS
Digital inputs setting
DI1 - Volume counter Enabled
DI2 - Water Flow switch Enabled
DI3 - Tank level Enabled
DI4 - Disabled
DI5 - Disabled
DI1 – Volume counter Enabled
DI4 - Disabled