Programming Instructions

Programming screen « Setup menu » Page 21/78
General programming instructions
d) 4…20mA analog input setting [1231]
Press to open the following screen.
 AI1 – Sensor Free chlorine
- Select the sensor type, on this selection button you will find the information of the input being
modified (AI1) and the currently selected sensor type (Free chlorine). Press to change it.
 Scale 0.1…10mg/l
- Select the sensor measurement scale, on this selection button you will find the information of the
currently selected scale (0.1…10mg/l).
Press to change it.
Each sensor has a « Customer » scale. By selecting this scale, it is then possible to select the low and
high level of the scale and the unit of measurement. (See next screen)
 Starting delay time 2 Minute(s)
- Enter boot delay (polarization). Here disabled for this type of sensor (2).
Press to open the numeric keyboard and enter the desired value.
Adjustment possible from 0 à 480 minute(s).
To delete a sensor
You must select « NONE » from the sensor list and save your configuration by pressing the “SAVE”
button.
AI1 – Free chlorine Enabled
Analog input setting
AI1 – Sensor Free chlorine
Scale 0.1…10mg/l
Starting delay time
minute(s)
2