Programming Instructions

Programming screen « Setup menu » Page 19/78
General programming instructions
« Customer » view
 Sensor – Scale – Temporization
- See previous section.
 Unit mS/cm
- Select the unit of measurement of the sensor, on this selection button we find the information of the
currently selected unit (mS/cm).
Press to change it.
 Value min. 0 mS/cm
- Low sensor value input. Here the current value is (0).
Press to open the numeric keyboard and enter the desired value.
 Value max. 100.00 mS/cm
- High sensor value input. Here the current value is (100.00).
Press to open the numeric keyboard and enter the desired value.
 K factor of the cell
- Enter the K factor of the cell. Here the current value is (1.00).
Press to open the numeric keyboard and enter the desired value.
Analog input setting
Scale Customer
Starting delay time
Minute(s)
Unit mS/cm
Value min. 0 mS/cm
Value max. 100 mS/cm
RI2 - Conductivity
Sensor enabled
OFF
cm
-1
1.00
K factor of the cell