Programming Instructions

Programming screen « Setup menu » Page 15/78
General programming instructions
2) Menu « Setup menu » - « ANALOG INPUTS » [0231]
« ANALOG INPUTS » menu will allow you to access the configuration of the sensors that will be
connected on the analog inputs.
Press to open the following screen.
Screen presents analog inputs that are already configured and those that are not used. By pressing an
already configured entry, you can change its configuration, or pressing an unused entry, configure its installation.
Entry already configured.
Press to edit its configuration.
Entry unused.
Press to configure its installation.
Option not available.
RI1 Temperature
RI2 Conductivity
SI1 Conductivity – Temperature – Flow switch (CTFS)
AI1 & AI2 Isolated 4…20mA inputs
For your comfort, you will find the notation of the RIx, SIx and AIx inputs silkscreen in front of the
corresponding connection terminal block of your device.
ANALOG
INPUTS
Analog inputs setting
RI1 – Temperature Enabled
RI2 - Conductivity Enabled
SI1 - Conductivity - Temperature - Flow switch (CTFS) Enabled
AI1 – Free chlorine Enabled
AI2 - Disabled
RI1 – Temperature Enabled
AI1 - Disabled