Programming Instructions

SYCLOPE COOLTOUCH setting Page 28/40
Communication programming instructions
g) Modbus Slave configuration |7731]
Press to open the following screen.
 Slave type CONTROLLER
- Selection of the type of slave connected on the RS485 bus, on this selection button we find the information
of the selected type (CONTROLLER). Press to change it.
 Address
- Entering the slave’s Modbus address. Caution it must be different from the Modbus address of your
regulator.
Press to open the numeric keyboard and enter the desired value.
Possible adjustment from 1 to 247.
 Test
- Pressing the Test button verifies that the slave is correctly connected. You must first make the RS485 wired
connection between the 2 devices and check that the Modbus configuration is identical on the 2 devices.
Both windows above appear after the configuration.
Save:
- When a modification is made, the « Save » button appears (floppy disk icon), you have to press it to
save your configuration
MODBUS
SLAVES
Slaves configuration
Slave type CONTROLLER Address 1 Test
Slave type NO Address 1 Test
Slave type NO Address 1 Test
Slave type NO Address 1 Test
RS485 Bus busy…
CLOSE (3)
xxxxxxxx
Device ID
CLOSE (5)