User`s manual

ManualsBrandsSYBA Manualscard readersCL-37004518

User’s Manual

GENERAL SPECIFICATION

Front panel I/O BOX with connected cables

INSTALLATION:

A. Make sure the computer power is off after shut down the computer, and then open

the cover of the computer.

B. Remove the 5.25"plastic cover from the computer where is the free bay you want

to install.

C. Install the I/O front panel to the empty bay, and screw it.

D. Connect the attached cables from the I/O FRONT PANEL to the correct

connectors where are on the motherboard when the I/O FRONT PANEL BOX is

installed.

E. Connect with the Power Connector from the power supply to I/O Front Panel.

Please refer to the picture below:

Summary of content (9 pages)

PAGE 1
User’s Manual GENERAL SPECIFICATION Front panel I/O BOX with connected cables INSTALLATION: A. Make sure the computer power is off after shut down the computer, and then open the cover of the computer. B. Remove the 5.25"plastic cover from the computer where is the free bay you want to install. C. Install the I/O front panel to the empty bay, and screw it. D.
PAGE 2
F. 1. USB Port Plug the USB module cable to the USB 2.0 connectors which is on the motherboard. 2. Audio Port Plug in the Audio Module Cable to the legacy AC'97 Audio pin header where is located on the motherboard.
PAGE 3
.1394 Port Plug the 1394 cable to the 1394 Port where is on the motherboard and make sure all the pins of connector which is connected are correct. 4. SPDIF_OUT Connect the S/PDIF module cable to the S/PDIF connector which is on the Motherboard.
PAGE 4
5. Serial ATA Port First Make sure the 4-pin power cable that from Power supply is connected to the correct location of the I/O board, and then plug the Serial ATA cable connecting to the Serial ATA port on the Motherboard from I/O PANEL.
PAGE 5
6. Card Reader Connect with the 5-pin USB cable from CN1 location of the Card reader PCB to another USB port where is on the motherboard.
PAGE 6
Front panel I/O Box Connectors 1. USB 2.0 Port: These two 4-pin Universal Serial Bus ports are available for connecting with USB 2.0 devices. 2. IEEE 1394: This 6-pin firewire connector is for IEEE1394 device. 3. SM Connector: This port is used for connecting with memory SM card. 4. CF/MD Connector: This port is used for connecting with memory CF or MD card. 5. SD/MMC Connector: This port is used for connecting with memory SD or MMC card.
PAGE 7
6. MS Connector: This port is used for connecting with memory MS card 7. 8.S/PDIF digital sound Connector: The technology turns your computer into a high-end entertainment system with a digital connector for powerful audio and speaker systems. 9. Microphone Connector: This port is used to connecting with a microphone. 10. LINE-OUT Connector: This port is used to connecting with a headphone or a speaker. 11. DC Power Connector: This 4-pin connector is used for connecting with SATA Power +12V or +5V. 12.
PAGE 8
2.
PAGE 9
BIOS setup program