Instructions for use T99000080-2

Shutdown Procedure
Always observe proper shutdown and cooling of the turbine. Failure to observe proper shutdown by not properly
cooling the unit will render damage and will void the warranty.
To shut down the turbine
1. Lower the stick to minimum
2. Lower trim to minimum
3. The motor will shut down and initiate a cooldown sequence by turning on the starter motor to an RPM defined in
motor parameters. This cool down speed is determined in cooling menu of ECU setup. The default cool down speed
is 7000 rpm. The motor turns continuously until a safe temperature is reached. Please note that it is normal with new
ECU releases for the starter to spin continuously until the motor is cooled. Previous firmware releases spun the
motor intermittently to save the life of the motor.
4. Turn off the fuel
5. Turn off power to the controller
6. Turn off power to your radio
ECU
The SWIWIN ECU was designed from the ground up and is based on 32 bit microprocessor functionality and designed
specifically for SWIWIN Turbines.
The ECU offers the following benefits: