User Manual

13
When connecting the GPI pin with ground, the setted function will be turned on, and goes out
when disconnecting.
Example 1: Under “GPI ” submenu, set “GPI control” to “On”, set “2
Pin” to “Red Tally”, when the pin 2 of the extenal GPI control unit is
connected with ground, the Tally light will display on the front panel which
will flashes in red around every second. When disconnected, the monitor
will not display tally light information.
Example 2: Under “GPI ” submenu, set “GPI control” to “On”, set “4
Pin” to “Scan Mode”, when the pin 4 of the extenal GPI control unit is connected with ground, the Scan
mode will change and follow the sequence: “Normal” →”Overscan”→”Native” .
6. UMD
Set “UMD”:
Select “Source ID”
(2) The underline flashes as a reminder on the bottom of the first letter. Revolve "MENU" to select the
letters; the letter will follow the sequence of the down below if clockwise revolved:
(3) Press “MENU” to save the current settings letter and then start to set the next letter.
Repeat step (2) and step (3), max 8 letters are supported.
Press “Exit” to quit and save the settings.
7. Marker
*1 When “Fit Marker” is “Off”, the size of safety area is benchmarked against the actual display screen,
accounting for 80% ~ 95% of actual display screen. When “Fit Marker” is “On”, the size of safety area
is benchmarked against the area inside the scales marker, accounting for 80% ~ 95% of the area
inside the scales marker.
Example: