User's Manual

The description of LED status indicator
Receiver FLOW2000
⑴ Antenna
⑵ ON/OFF：Power switch
⑶ USB：Micro USB, software upgrade interface
⑷ Link：Wireless status indicator
⑸ Video：Video signal indicator
⑹ Power：Power status indicator
⑺ DC in：Support DC 7-34V voltage input, 5.5mm (outer diameter) /2.1mm (inner diameter). Outside: negative,
Inside: positive
⑻ OLED：0.96-inch OLED
⑼ Five-direction switch：Five-direction adjustment button. (adjust the display menu to switch and confirm in
five directions up, down, left, right, and vertical)
⑽ Installation thread：1/4”-20 thread, Use the package supplied articulating arm trestle to install the device to
the camera
⑾ HDMI OUT: HDMI output (HDMI-A type connector)
⑿ SDI out: SDI output (BNC connector)
⒀ Battery plate：”F” plates can be used. We recommend SWIT batteries like: S-8972, S-8970, S-8770, S-8975
compatible with SONY “L” series NP-F770/970.
Device LED indicator Status Description
FLOW2000
Transmitter
Power
Constant On Power connected and switched on
Off Power disconnected and switched off
Video
Constant On There is recognizable video signal input
Flash There is no recognizable video signal input
Link
Constant On The wireless network connection is normal
Flash The wireless network connection is abnormal