S-4913T/R Wireless HD Transmission System User Manual Ver:V1.0V01 Please read this User Manual throughout before using.
Preface Congratulations on your purchase of this product. Please read this user manual carefully. 1 ． All internal technologies of this product are protected, including device, software and trademark. Reproduction in whole or in part without written permission is prohibited. 2 ． All brands and trademarks of SWIT Electronics Co., Ltd. are protected and other relative trademarks in this user manual are the property of their respective owners.
For Your Safety Before start, please follow the safety precautions below Do not try the followings: 1. Unauthorized repairs or parts replacement or other operations. 2. Inappropriate placement including but not limited to lighting, fire, exposure to rain, water or gas. 3. Switch to the power not in the voltage allowable range The product 1. Do not use the products near water or in high humidity environments. 2.
1. Product Introduction This broadcast industry wireless system includes S-4913T transmitter and S-4913R receiver, adopts WHDI (OFDM) technology, supports uncompressed HDMI wirelessly transmitted in 200 meters scale, and with less than 1ms latency, which is widely used in on-site shooting and director monitoring. 2.
3. Product Instruction Transmitter S-4913T Front View Rear View ⑴ HDMI: HDMI input (HDMI-A type connector) ⑵ DC 7-17V: DC Power input socket Voltage range: DC 7-17V; Connector: 5.5mm/2.
S-4913R Receiver Front View Rear View ⑴ Power: Switch the power on/off ⑵ SDI OUT: 3G/HD-SDI output x2 (BNC connector) ⑶ V-mount power adaptor Connect the S-4913R to V-mount devices, and supply DC power ⑷ LED status indicators Including Power, Video Signal and Wireless connection condition indicators ⑸ DC-IN ⑹ ⑺ Power the S-4913R via 4-pin XLR adaptor. Voltage range: DC 8-17V; Pin assign: No.1: negative, No.
4. System Connection 1. Check the match codes on the products. The S-4913T and S-4913R with same match codes are allowed to transmit. (For example: match the S-4913T with “TRANSMITTER ***801” code and the S-4913R with “RECEIVER ***801” code.) 2. Connect the HDMI video source with the “HDMI” port of S-4913T transmitter. 3. Connect the “SDI OUT” port of S-4913R receiver with SDI monitor or receiving devices. 4.
5. Trouble-Shooting If the receiver failed to output video correctly, and OSD displayed as Pic (5) or Pic (6), please find the solution from following chart: Pic (5) OSD Display SearchingL Connected to TX1, Please Check Video Source Please wait, this action may take up to 60SecL Pic (6) Possible Causes Solution The transmitter S-4913T is powered off Check the power supply of the transmitter.
6. Specifications Model S-4913T S-4913R Input HDMI input ×1 Wireless receiving Output Wireless transmitting 3G/HD-SDI output ×2 HDMI input SDI output 1080p (60 / 59.94 / 50) Video format 1080psf (30 / 29.97 / 25 / 24 / 23.98) The same as input HDMI format 1080p (30 / 29.97 / 25 / 24 / 23.98) 1080i (60 / 59.94 / 50) 720p (60 / 59.94 / 50) Wireless frequency Radio modules Max Transmission distance Latency Power consumption Radio power 5.1 ～ 5.
