User's Manual

7. Trouble shooting
If the receiver failed to output video correctly, the possible causes are as below; please find the solution
from following chart:
8. Specification
The receiving
video
No display
Poor
Video quality
Possible causes
The transmitter or the receiver is not
powered on
The antennas are not installed
properly and screwed tightly
Bad connection of video cable
Video format is not supported
Bad connection with video cable
The wireless transmission is
disturbed by environment
The transmission distance is out of
effective range
Solution
Check power connection and switch on
the transmitter and receiver
Install the antennas properly and screw
tightly of both transmitter and receiver
Check video cable connection of both
transmitter and receiver
Change the output video format of the
camera
Reconnect reliably
Wait for 1 minute or reboot the transmitter
and receiver
Put the transmitter closer to the receiver
Model
Input
Output
Video format
Wireless frequency
Modulation mode
Transmission distance
Power consumption
Input voltage
Working environment
Dimension
Net weight（Without antenna）
Net weight（With antenna）
CURVE500 Transmitter CURVE500 Receiver
HDMI×1
HDMI×1
1080I（60/59.94/50）/1080PsF（24/23.98）/720P（60/59.94/50)/1080P
（60/59.94/50/30/29.97/25/24/23.98）
5180-5220MHz and 5760-5820MHz
OFDM Support 16QAM、64QAM、QPSK、BPSK modulation mode
150m（Line of sight）
≤7.5W
DC/Battery：7～17V
Temperature：0℃~+40℃
114.18×69.55×28（mm）
190.7g
198.6g
/
HDMI×2
≤7W
DC/Battery：7～17V
114.18×69.55×28（mm）
193.3g
201g
5182.5-5222.5MHz and 5762.5-5822.5M
Hz