Instructions
HR
Blood
BP
Heart Rate
This interface automacally turns on heart rate measurement. At the same me,
the green light of PPG at the inner side is turned on and the measurement begins.
Value will be measured in 30 to 60 seconds.
Blood Pressure
Enter the interface and start the blood pressure
measurement. At the same me, the green light of PPG at
the inner side is turned on and the measurement begins.
Data will be visible in about 10 seconds and the full
measurement will take 30-60 seconds.
Hint: Sensors in the watch measure the highest and lowest value of the photo-
plethysmographic signal (PPG) - the vessel width change. It is detected by light
irradiaon and absorbance measurement. The PPG sensors are located on the
boom of the watch. To generate the PPG signals, the skin is illuminated with
green LED light, resulng in a reecon of the blood cells under the skin. The
reected poron is registered and recorded.