Datasheet

Swisstac
Mounting instruction
7
02.2009
The switch is mounted in a fascia or control panel in three steps:
1. Detach front section just in released position, as in drawing.
2. Insert switch from the back side in fascia/control panel.
3. Snap on front section and tighten fixing nut.
0
0
Imortant for protection class IP 65 !
With models to IP 65, the sealing ring
1)
is already fitted. This must be removed if the SWISSTAC emergency-stop legend plate
(IP 65 model) is used.
Sealing ring
2)
is fitted as standard in models to IP 65.
>
Note !
Mounting : The torque with which the fixing nut ist tightened must not exeed 50 Ncm.
Dismounting : Dismantling of switching element just with dismantling tool.
0
>
The switch is mounted in a fascia or control panel in three steps:
1. Detach terminal block as in drawing, remove fixing nut.
2. Insert switch from the front in fascia/control panel.
3. Reassemble the switch in the reverse order.
0
0
>
Stop pushbutton 55 - 70 mm, key to unlock
Zero position Legend plate Wiring diagram
Emergency-stop switch foolproof, EN IEC 60947-5-5
Keylock switch 45 mm
To detach terminal block