Datasheet

Swisstac
Mounting instruction
8
02.2009
The switch is mounted in a fascia or control panel in three steps:
1. Remove front section as in drawing.
2. Insert switch from the back side in fascia/control panel.
3. Snap on front section (see note) and tighten fixing nut.
0
0
Note !
To assemble, the key must be at the zero position. The symbol 0 is at the top, and on the terminal block the circuit diagram is uppermost.
>
The switch is mounted in a fascia or control panel in three steps:
1. Remove front section as in drawing.
2. Insert switch from the back side in fascia/control panel.
3. Snap on front section (see note) and tighten fixing nut.
0
0
Note !
To assemble, the key must be at the zero position. The symbol 0 is at the top, and on the terminal block the circuit diagram is uppermost.
>
The switch is mounted in a fascia or control panel in three steps:
1. Detach terminal block as in drawing, remove fixing nut.
2. Insert switch from the front in fascia/control panel.
3. Reassemble the switch in the reverse order.
0
0
>
Keylock switch 55 mm
Zero position Wiring diagram
Keylock switch 70 mm
Zero position Wiring diagram
Selector switch 45 mm
To detach terminal block