Datasheet

Swisstac
Mounting instruction
6
02.2009
>
The switch is mounted in a fascia or control panel in two steps:
1. Insert switch from the back side in fascia/control panel.
2. Snap on bezel and tighten fixing nut.
0
0
>
The first time the button is pressed, the gland is forced into its groove and becomes effective.
0
>
The switch is mounted in a fascia or control panel in three steps:
1. Detach front section just in released position, as in drawing.
2. Insert switch from the back side in fascia/control panel.
3. Snap on front section and tighten fixing nut.
0
0
Imortant for protection class IP 65 !
With models to IP 65, the sealing ring
1)
is already fitted. This must be removed if the SWISSTAC emergency-stop legend plate
(IP 65 model) is used.
Sealing ring
2)
is fitted as standard in models to IP 65.
>
Pushbutton illuminated 55 - 70 mm
Lens Bezel Illuminated pushbutton
Pushbutton illuminated 55 - 70 mm, sealing gland and sealing ring
Stop pushbutton 55 - 70 mm, twist to unlock
Zero position Legend plate Wiring diagram