Datasheet

Swisstac
Mounting instruction
5
02.2009
The switch is mounted in a fascia or control panel in two steps:
1. Insert indicator from the back side in fascia/control panel.
2. Snap on bezel and tighten fixing nut.
0
0
>
The press ring is fitted between glan and lens. The seal is effective when the lens is snapped into place.
0
>
The buzzer is mounted in a fascia or control panel in two steps:
1. Insert buzzer from the back side in fascia/control panel.
2. Snap on bezel and tighten fixing nut.
0
0
>
The switch is mounted in a fascia or control panel in three steps:
1. Detach terminal block as in drawing, remove fixing nut.
2. Insert switch from the front in fascia/control panel.
3. Reassemble the switch in the reverse order.
0
0
Note: Type-identification on legs of actuator !
Indicator 30 - 70 mm
Lens Bezel Indicator
Indicator 30 - 70 mm, sealing gland and sealing ring
Buzzer 30 - 55 mm
Buzzer element Bezel Buzzer housing
Pushbutton illuminated 35 mm
To detach terminal block