User's Manual

ITC2100-NA Operation and Service Manual Version 1.0
© SWISSPHONE Wireless AG
Page 73 of 129
6.6.3.2 RS 232
The serial port (COM 1) can be used for local alarming. However, local output (see chapter
6.6.2.3) cannot be enabled at the same time. This must be disabled.
Fig. 6-38: Configuration of the local alarming interface RS232
Field
Description
Local alarming:
Switch on ("COM 1") or switch off ("Disabled) local alarm. When
switched on, an alarm message can be forwarded via the Control-
ler's serial interface
Protocol:
Selection of the communication protocol "MIP11" or "Sonnenburg"
from the local network alarm controller to the ITC (Controller's
serial interface). "MIP11" is Swissphone's freely available access
protocol. "Sonnenburg" is used with a Sonnenburg network alarm
controller.
Messaging:
Selection of the type of message transmission. Currently "Broad-
cast is the only possible setting. This means that the message is
transmitted to the complete network.
Local output:
See chapter 6.6.2.3 Local output.
RX Monitoring:
See chapter 6.6.2.3 Local output.
Note: Because the Controller only has one serial interface (COM 1) available, either the
function "Local alarm" or the "Local output" can be used.