User's Manual

ITC2100-NA Operation and Service Manual Version 1.0
© SWISSPHONE Wireless AG
Page 70 of 129
ITC2100 Firmware update to version 2.0:
Important information:
On version 2.0, timing to the air interface has been changed and it is no longer compatible
with earlier versions. An existing network must therefore be completely updated or com-
plete rings. If a new base station is to be installed in an existing network, in which the base
stations run on versions earlier than V 2.0, the timing of the newly installed base station
must be set to the earlier version under Configuration  Radio network (RIC / Baudrate) ->
Netversion. However, the intention is to bring all networks to the latest software situation
step by step.
Update procedure:
 See chapter 4.1 and chapter 4.2: Connect the laptop to the LAN connection ETH using
a crossover cable. Enter the laptop's IP address 192.168.1.10 under network charac-
teristics. In the browser make contact with the base station (http://192.168.1.1). User
and password are both: service.
 After logging in, select Configuration -> Upload Update.
 With Browse select directory and file update_x.xx.zip and then File upload…. After
the upload has been completed restart the base station.
Important for the ITC2100-NA:
The ITC2100-NA must run on a SW version ≥ V2.25, i.e. from Kernel version 2.4.10-1.2. It
is not permitted to update a version earlier than V2.25 (see chapter 8.5).
Important: Please maintain the following update order!
A large update e.g. from V1.03 to V2.10 must be carried out in stages according the follow-
ing scheme: