User's Manual

ITC2100-NA Operation and Service Manual Version 1.0

Page 69 of 129

6.6.2.5 Upload Update

No messages should be sent from the master base station and the Digicom (Swissphone

alarming input software) should not be started during loading of a new firmware release to

the ITC2100. Otherwise, this could result in corrupt data during the update. Disconnect the

antenna from the base station to prevent reception. After clicking the link "Update file up-

load" the system change in a deeper operating system level (run level). This change lasts

approx. 10 seconds. The following window appears:

Fig. 6-36: Software update

Click the button "Browse" to select the update file (ZIP file) and then click "File upload" to

upload the file. The ITC then conducts a soft reset and is ready for operation again after

approx. 10 seconds. For base stations with SW version <1.30 a new start must be carried

out. From version 1.30 a new start is carried out automatically after the update.